Skip to main content
NetApp Knowledge Base

Repurposing an ONTAP node gives "Error: Interface e0m does not exist"

  1. Last updated
  2. Save as PDF
Views:
224
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
CORE
Last Updated:

Applies to

  • ONTAP 9
  • ONTAP Select

Issue

If you are following the instructions in this KB - How to repurpose a Data ONTAP 8.1.x or later 7-Mode node to ONTAP 9, or just using Option 7 at the Boot menu to install new software, the following error may be seen when entering an interface:

Interface e0m does not exist

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.