Skip to main content
NetApp Knowledge Base

Is it possible to use the "statistics volume show" command to output total values for a FlexGroup volume as a whole volume?

  1. Last updated
  2. Save as PDF
Views:
40
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Answer

No, it can't. The following is a sample when the target volume is a flexgoup volume:

ontap913::> statistics volume show -volume fg_src*

ontap913 : 5/9/2024 17:32:15

                                       *Total Read Write Other  Read Write Latency
      Volume       Vserver   Aggregate    Ops  Ops   Ops   Ops (Bps) (Bps)    (us)
------------ ------------- ----------- ------ ---- ----- ----- ----- ----- -------
fg_src__0004 svm1_ontap913 aggr2_node1      0    0     0     0     0     0       0
fg_src__0003 svm1_ontap913 aggr1_node1      0    0     0     0     0     0       0
fg_src__0002 svm1_ontap913 aggr2_node1      0    0     0     0     0     0       0
fg_src__0001 svm1_ontap913 aggr1_node1      0    0     0     0     0     0       0

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.