After ONTAP revert, system node upgrade-revert show command displays "Status:not-needed"

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 124

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: core

Last Updated:

Applies to

ONTAP 9

Issue

After ONTAP revert(9.7 -> 9.6), system node upgrade-revert show command displays Status:not-needed

　　--------------------------------------------------------------------------------------------------
　　Node:node1                          Status:not-needed

　　Status Message: The node configuration is up-to-date. No upgrade is needed

　　Vers Phase       Status    Upgrade Phase Status Message
　　------------------------------------------------------------------------------
　　510  pre-root    applied   No upgrade is required for this phase.
　　510  pre-apps    applied   Upgrade successful.
　　510  post-apps   applied   Upgrade successful.
　　700 pre-root    applied   No upgrade is required for this phase.
　　700  pre-apps    applied   Upgrade successful.
　　700  post-apps applied   Upgrade successful.
　　900  pre-root    applied   No upgrade is required for this phase.
　　900  pre-apps    applied Upgrade successful.
　　900  post-apps   applied   Upgrade successful.
　　9 entries were displayed.
　　-------------------------------------------------------------------------------------------------

Re-running the revert command doesn't change the status of not-needed

::> set advanced ::*> system node upgrade-revert upgrade -node node1 The node configuration is up-to-date. No upgrade is needed.