Skip to main content
NetApp Knowledge Base

Data ONTAP 8: After replacing a failed disk with a new disk, which shows the LED as either green or red, sysconfig -r output shows the drive as broken

Views:
1,035
Visibility:
Public
Votes:
0
Category:
clustered-data-ontap-8
Specialty:
HW
Last Updated:

Applies to

  • Clustered Data ONTAP 8 
  • Data ONTAP 8 7-Mode 
  • Data ONTAP 7 and earlier

Issue

Replaced a failed disk with a new disk

New disk LED is green

sysconfig -r output shows the drive as broken

Disk still reported as broken although it has been replaced.

New disk LED is red


 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.