Skip to main content
NetApp Knowledge Base

e0M port link status does not change when removing or connecting a network cable

  1. Last updated
  2. Save as PDF
Views:
417
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF A400
  • FAS 8300, FAS8700
  • ONTAP 9.7P1

Issue

  • When e0M is up status, removing the network cable from the wrench port doesn't change the link status from "up" to "down"
  • Conversely, if there no cable is attached to the wrench port and the port status is "down" and then a network cable is connected , e0M port link status remains "down" -- it does not ever change to "up"
  • Node management access can be affected because LIF failover does not occur due to a valid link status change

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.