Skip to main content
NetApp Knowledge Base

Why are my partition sizes inconsistent on my MetroCluster IP active-passive system?

  1. Last updated
  2. Save as PDF
Views:
51
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • MetroCluster IP

Answer

MetroCluster IP active-passive was not initialized in a supported configuration which resulted in differing partition sizes.

Additional Information

See How to initialize a MetroCluster IP for an active-passive setup? for supported configurations and initialization instructions
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.