Skip to main content
NetApp Knowledge Base

What command can be used to monitor the storage efficiency progress on a FlexGroup volume?

  1. Last updated
  2. Save as PDF
Views:
306
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9.8
  • FlexGroup

Answer

Storage Efficiency job takes a long time to compete on large FlexGroup volumes, in order to have a granular way to check on the Storage Efficiency progress:
  • Check SIS-STATUS-L.XML in ASUP.
  • volume efficiency show -instance can only display the Storage Efficiency progress for the entire FlexGroup, it can't display the progress for the member volumes. There is a diag level command that could be used to display the progress on each individual volume. 

    Please contact NetApp Technical Support or log into the NetApp Support Site to create a case. Reference this article for assistance with the solution. 

    • The solution requires Diagnostic-level recovery. 
    • The use of Diagnostic commands and recovery steps is potentially disruptive and should only be used with guidance from NetApp Support. 

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.