Skip to main content
NetApp Knowledge Base

The status of e0M not changes even remove or connect network cable

Views:
384
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
HW
Last Updated:

Applies to

  • AFF-A400
  • FAS 8300
  • ONTAP9.7P1

Issue

  • When e0M is up status, remove the network cable can't change the status from "up" to "down".
  • Conversely, if there no cable is attached to e0M port and the port status is "down", after connecting cable , the port status remains "down" and will not change to "up" indefinitely.
  • Node management access can be affected because LIF failover does not occur.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.