Skip to main content
NetApp Knowledge Base

Takeover status is flapping between Disabled and Enabled due to unstable HA interconnect link

Views:
359
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • FAS/AFF systems
  • MetroCluster IP

Issue

  • The failover is disabled and enabled automatically between a HA pair due to unstable HA interconnect link:

[Netapp1-01: cf_main: cf.fsm.takeoverOfPartnerDisabled:error]: Failover monitor: takeover of Netapp1-02 disabled (unsynchronized log).
[Netapp1-01: cf_main: cf.fsm.takeoverByPartnerDisabled:error]: Failover monitor: takeover of Netapp1-01 by Netapp1-02 disabled (unsynchronized log)

[Netapp1-01: cf_main: cf.fsm.takeoverOfPartnerEnabled:notice]: Failover monitor: takeover of Netapp1-02 enabled
[Netapp1-01: cf_main: cf.fsm.takeoverByPartnerEnabled:notice]: Failover monitor: takeover of Netapp1-01 by Netapp1-02 enabled

  • The HA interconnect port is disabled and enabled at the same time:

[Netapp1-01: kernel: netif.linkDown:info]: Ethernet e1a: Link down, check cable.
[Netapp1-01: kernel: netif.linkUp:info]: Ethernet e1a: Link up.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.