Skip to main content
NetApp Knowledge Base

System unable to boot due to firmware fault detected on SAS adapter

  1. Last updated
  2. Save as PDF
Views:
313
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
HW
Last Updated:

Applies to

  • AFF-A220
  • FAS 27xx series
  • ONTAP 9

Issue

  • System is unable to boot.
  • Following message is observed during the boot process:

[node-01:sas.adapter.firmware.fault:notice]: Detected firmware fault 0xffffffff on SAS adapter 0a.

  • SYSCONFIG-A shows that the firmware of the adapter is up to date:
slot 0: SAS Host Adapter 0a (PMC-Sierra PM8070 rev. C, SAS, )
Firmware rev: 03.08.09.00

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.