Skip to main content
NetApp Knowledge Base

Spare Disk reporting "Awaiting Savecore" in Clustered Data ONTAP and ONTAP 9

Views:
1,421
Visibility:
Public
Votes:
1
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9

Issue

  • The savecore command cannot complete leaving the spare disk stuck with "Awaiting savecore" status.

Pool0 spare disks

RAID Disk       Device          HA  SHELF BAY CHAN Pool Type  RPM  Used (MB/blks)    Phys (MB/blks)
---------       ------          ------------- ---- ---- ---- ----- --------------    --------------
Spare disks for block checksum
spare           9c.11.8P3       9c    11  8   SA:B   0   SSD   N/A 61153/125241856   61161/125258240
spare           9c.11.11P3      9c    11  11  SA:B   0   SSD   N/A 61153/125241856   61161/125258240
spare           9c.11.8P1       9c    11  8   SA:B   0   SSD   N/A 3632101/7438543360 3632109/7438559744 (Awaiting savecore)

  • If the disk stuck in "awaiting savecore" is the only applicable spare disk needed for a reconstruction, latency as a result of disk utilization due to degraded raid group could result

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.