Skip to main content
NetApp Knowledge Base

SYSCONFIG -AC wrongly reports the Flash cache model as X3315A instead of X3311A

  1. Last updated
  2. Save as PDF
Views:
156
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
HW
Last Updated:

Applies to

  • ONTAP 9
  • FAS8700 (ONTAP 9.12.1 and later)
  • FAS8300 (ONTAP 9.11.1P7 and later)

Issue

  • The output of SYSCONFIG -AC reports X3311A as X3315A in slot 6:

::> system node run -node <node> sysconfig -AC

sysconfig: slot 6 OK: X3315A: M.2 2TB NVMe Drive -> slot 6 should show X3311A instead of X3315A
sysconfig: slot 7 OK: X3311A: M.2 1TB NVMe Drive

  • The SYSCONFIG -A recognizes slot6 adapter as X3311A correctly:

::> system node run -node <node> sysconfig -a

    slot 6: Flash Cache NVMe
        Serial Number:      XXXXXXXXXXXXXX
        Part Number:        119-00329
        Hardware Revision:  D0
        Firmware Version:   NA01
        Firmware File:      X3311_S000PM9A3NVM
        Model Name:         X3311A
        Capacity:           1024 GB
        State:              ok

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.