Skip to main content
NetApp Knowledge Base

The link LED of SAS port is OFF without any error

  1. Last updated
  2. Save as PDF
Views:
425
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
HW
Last Updated:

Applies to

  • FAS platform
  • ONTAP 9

Issue

The link LED of SAS port 0a is off without any error.

The link status in "sysconfig -a" shows "<up>" and the port function is normal.

Example:

slot 0: SAS Host Adapter 0a (PMC-Sierra PM8001 rev. C, SAS, <UP>)
        Firmware rev: 01.12.06.00
        Base WWN: 5:00a098:00371c7:40
        Phy State: [0] Enabled, 6.0 Gb/s
            [1] Enabled, 6.0 Gb/s
            [2] Enabled, 6.0 Gb/s
            [3] Enabled, 6.0 Gb/s

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.