Skip to main content
NetApp Knowledge Base

Is there a command I can run to determine if there is any Indirect cluster traffic?

  1. Last updated
  2. Save as PDF
Views:
327
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
perf
Last Updated:

Applies to

ONTAP 9

Answer

  • Run the following command on the cluster

cluster::> qos statistics volume latency show

Workload            ID         Latency         Network       Cluster       Data       Disk        QoS      NVRAM
--------------- ------ ---------- ---------- ---------- ---------- ---------- ---------- ----------
-total-              -        110.35ms        110.02ms        1.65ms        0ms        0ms        0ms        0ms
-total-              -        38.830ms        167.22ms        0ms           0ms        0ms        0ms        0ms
-total-              -        117.76ms        117.56ms        0ms           0ms        0ms        0ms        0ms

Refer to the "Cluster" column and if it has a value > 0, then there is traffic on the cluster network.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.