Skip to main content
NetApp Knowledge Base

Incorrect port gets automatically set as Cluster port during Cluster Setup

  1. Last updated
  2. Save as PDF
Views:
1,715
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
HW
Last Updated:

Applies to

Issue

  • During cluster setup the system keeps using different ports
    • Example: 
      • X60132A Card is installed in slots 1 and 2, intended to be used as Host card
      • X60130A Card is installed in slots 3 and 4, intended to be used as NVMe Storage network and Cluster network connections
  • The desired port is not detected as cluster port, has to be set manually after booting ONTAP
  • An incorrect port is detected as cluster port and marked as HA Interconnect
  • Cabling has both desired ports connected to cluster switch, while the other ports are connected to data switch, as per the installation guide

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.