Skip to main content
NetApp Knowledge Base

ISL not showing correct config on SN2100 cluster switch

  1. Last updated
  2. Save as PDF
Views:
110
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
HW
Last Updated:

Applies to

SN2100

Issue

ISLs on SN2100 cluster switches will not link to partner switch because of config mismatch.
 
cumulus@sw1:mgmt:~$ net show interface all
State  Name         Spd   MTU    Mode        LLDP                 Summary
-----  -----------  ----  -----  ----------  -------------------  -----------------------
UP     swp15        100G  9216   Default  <<<     sw2 (swp15)
UP     swp16        100G  9216   Default  <<<     sw2 (swp16)
 
 
cumulus@sw2:mgmt:~$ net show interface all
State  Name         Spd   MTU    Mode        LLDP                 Summary
-----  -----------  ----  -----  ----------  -------------------  -----------------------
UP     swp15        100G  9216   BondMember       sw1 (swp15)      Master: cluster_isl(DN)
UP     swp16        100G  9216   BondMember       sw1 (swp16)      Master: cluster_isl(DN)

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.