Skip to main content
NetApp Knowledge Base

False alert about IOM6 and IOM12 stack mixing when adding IOM12B

  1. Last updated
  2. Save as PDF
Views:
237
Visibility:
Public
Votes:
1
Category:
fas-systems
Specialty:
HW
Last Updated:

Applies to

Config Advisor versions prior to 2.24, Firmware 602 and Openrule 601

Issue

  • Config Advisor shows the following error for cable checks after adding IOM12B modules to existing IOM12 stack:

"IOM6 and IOM12 disk shelves are not supported in the same stack 1"
"IOM6 and IOM12 disk shelves are not supported in the same stack 2"

  • There are no IOM6 modules in the stack and cabling is verified to be correct as per best pratices for MPHA

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.