Skip to main content
NetApp Knowledge Base

EMS reports "cmds.sysconf.logErr:notice" after upgrading ONTAP to 9.3

Views:
108
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

ONTAP 9.3

Issue

  • EMS reports "cmds.sysconf.logErr:notice" after upgrading ONTAP to 9.3P21.
Example:
 
[Node01: sysconfig_periodic_checker: cmds.sysconf.logErr:notice]: sysconfig: slot 1: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1). sysconfig: slot 2: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1). .
 
  • X1133A-R6 HBA cards are installed, but ONTAP instead displays a message about an X1145A HBA card in the output of the sysconfig -ac command.

Before:

sysconfig: slot 1 OK: X1133A: Broadcom LPe16004 rev. A0
sysconfig: slot 2 OK: X1133A: Broadcom LPe16004 rev. A0

After upgrading ONTAP to 9.3:

sysconfig: slot 1: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1).
sysconfig: slot 2: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1).

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.