Skip to main content
NetApp Knowledge Base

Cluster switch log collection stuck in "initiated" state due to firewall restrictions

  1. Last updated
  2. Save as PDF
Views:
85
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco Switches
  • Broadcom BES-53248
  • Cluster switch / MetroCluster IP switch
  • FAS/AFF Platforms
  • ONTAP 9

Issue

  • Cluster switch log collection fails and get stuck in the initiated state
Cluster::> system cluster-switch log show
Log Collection Enabled: true
Index  Switch Log               Timestamp           Status
------ ------------------------ ------------------- -----------
1  ClusSwitch01             -                   initiated
2  ClusSwitch02             -                   initiated
2 entries were displayed.
 
  • SCP and SSH protocols are enabled and correctly configured on both switch and cluster
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.