Skip to main content
NetApp Knowledge Base

Cluster HA is not working correctly after ONTAP upgrade

  1. Last updated
  2. Save as PDF
Views:
89
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • Metro Cluster

Issue

  • After MCC ONTAP upgrade the Cluster HA reports not working correctly
Cluster::> cluster show
Node Health Eligibility
--------------------- ------- ------------
Cluster-01 true true
Cluster-02 true true

Warning: Cluster HA is not working correctly. Make sure that both nodes are
healthy by using the "cluster show" command; then reconfigure cluster
HA to correct the configuration. Check the output of "cluster ha
show" following the reconfiguration to verify node health. If
reconfiguring cluster HA does not resolve the issue, contact
technical support for assistance.
2 entries were displayed.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.