Skip to main content
NetApp Knowledge Base

Cannot apply new configuration to Nvidia cluster switch due to link state value

  1. Last updated
  2. Save as PDF
Views:
83
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

Nvidia SN2100 cluster switch

Issue

  • When trying to change the management IP address on the switches, the following error is seen on applying the configuration:

cumulus@switch2:mgmt:~$ nv set interface eth0 ip address 10.10.10.10/24
cumulus@switch2:mgmt:~$ nv config save
saving
saved [rev_id: applied]
cumulus@switch2:mgmt:~$ nv config apply
verifying
Invalid config [rev_id: 9]
Config invalid at interface.swp2s1.link.state: One value must be set

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.