Skip to main content
NetApp Knowledge Base

BMC_EMMCMountErr sensor is displayed after upgrading BMC firmware to 15.12

  1. Last updated
  2. Save as PDF
Views:
47
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF A250, AFF C250, ASA A250, ASA C250, FAS500f
  • Baseboard Management Controller (BMC)

Answer

  • BMC_EMMCMountErr sensor is displayed after upgrading BMC firmware to 15.12

BMC > system sensors show
Sensor name      | reading | unit | status| lnr | lcr | lnc | unc    | ucr | unr
BMC_EMMCMountErr | 0.000   | hit  |   ok  | na  | na  | na  | 10.000 | na  | na
 

  • The BMC_EMMCMountErr sensor specifically monitors the status of the eMMC (embedded MultiMediaCard) storage device used by the BMC.
  • An error reported by this sensor indicates that the BMC is experiencing issues mounting the eMMC storage, which can affect the BMC's ability to function properly.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.