Skip to main content
NetApp Knowledge Base

ACP firmware download fails due to "Could not install new microcode on ACPP firmware"

Views:
323
Visibility:
Public
Votes:
2
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

IOM6 shelf module

Issue

When attempting to update the ACP firmware on an IOM6 module, following error is observed:

INFORMATIONAL acp.fw.download.failed: Firmware download on 11b.29.B (NA) failed with status (Could not install new microcode on ACPP firmware), (disk shelf serial number: XXXXXXXXXXXXXXX).

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?