Skip to main content
NetApp Knowledge Base

Volume creation fails with Replication Service Recovering error

  1. Last updated
  2. Save as PDF
Views:
185
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • Snapmirror
  • Encryption

Issue

Volume creation fails with below error:
 
Error: command failed: [Job xxxxx] Job failed: Failed to create the volume on node "node1". Reason: The MetroCluster or Vserver DR Configuration
       Replication Service is recovering. Issue the "metrocluster check config-replication show -instance" command or the "snapmirror config-replication status show" command and follow its guidance. If there is no guidance, wait a few minutes and then try the command again.
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.