Skip to main content
NetApp Knowledge Base

Unable to create SVMDR with vserver that hosts applications

  1. Last updated
  2. Save as PDF
Views:
258
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9 and later
  • SVM DR

Issue

When attempting to create an SVM DR relationship with a vserver that hosts applications: 
 
Operation to create a destination endpoint and create a SnapMirror relationship failed. Reason: Out of 1 endpoints, 0 endpoints have been protected and protection has failed for 1 endpoints. List of paths that failed protection and reasons for failure: SVM1: : Vserver protection failed for Vserver "NAS". Reason: Failed to create Vserver relationship information. Reason: A Vserver DR relationship between Vserver "SVM1" and Vserver "SVM1_DR" is not supported because Vserver "SVM1" hosts one or more applications which are not MAX Data applications. Vserver DR Source Vservers that host applications can only host MAX Data applications.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.