Skip to main content
NetApp Knowledge Base

Snapmirror resync failing with below error Volume location not found

  1. Last updated
  2. Save as PDF
Views:
25
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • SVM DR
  • Cluster Peering

Issue

Failed to get information for source volume "<>" for setup of transfer. (Failed to get volume attributes for <>. (Volume location not found. Either the system is busy or the peer cluster is not Available. Wait a few minutes and try the operation again. If the volume is on a remote cluster, before retrying the operation, use the "cluster peer show" command to check the availability.)

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.