Skip to main content
NetApp Knowledge Base

Snapmirror resync error: The protection type is not the same on the peer Vservers

  1. Last updated
  2. Save as PDF
Views:
79
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
dp
Last Updated:

Applies to

ONTAP 9

Issue

When performing a snapmirror resync between a broken off source and destination SVM the command fails with the following error:
 
error: command failed: The protection type of the following volumes is not the same on the peer Vservers "Peer" and "Peer_dr": <Volume>. To change the protection type use the "volume modify -vserver <vserver-name> -volume <volume-name> -vserver-dr-protection <protection-type>" command, and try the operation again.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.