Skip to main content
NetApp Knowledge Base

SVM DR resync failing on newly created volume

Views:
318
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
DP
Last Updated:

Applies to

  • ONTAP 9
  • SVM DR
  • Resync
  • Volume

Issue

During an SVM DR resync the following error is reported:
 
Error: command failed: The following volumes "<volume>" on the destination Vserver are new volumes and do not correspond with the volumes on the source Vserver. Delete them using the (privilege: advanced) "volume delete -force" command. When this command completes successfully, try the operation again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.