Skip to main content
NetApp Knowledge Base

SVM-DR for FlexGroup fails with "SnapMirror relationship is not operational yet. Wait a few minutes, then try the operation again"

  1. Last updated
  2. Save as PDF
Views:
20
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • ONTAP 9 
  • SnapMirror
  • SVM-DR
  • FlexGroup

Issue

  • SVM-DR of FlexGroup fails with the following Error :  "Transfer for volume "f1234" failed. Reason: SnapMirror relationship is not operational yet. Wait a few minutes, then try the operation again."
  • Snapmirror_audit log :

"Fri Jul  5 18:41:51 CEST 2024 FlexGroupSetup[Jul  5 18:41:51]: Operation-Uuid=b3f64a97-1152-4cf2-8f7f-f103fb76dfba Group=none Operation-Cookie=0 action=End source=f1234 destination=f1234 status=Failure message=CG failed to join the group.(Internal error: CM timed out.)"

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.