Skip to main content
NetApp Knowledge Base

Is it possible to modify a dp-destination SVM's admin-status to up?

  1. Last updated
  2. Save as PDF
Views:
1,989
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SVM DR

Answer

  • The admin status can be only running on the destination vserver if it’s not stopped manually as described on Replicating an entire SVM configuration(Step 5)
  • Once the destination vserver's admin-status is stopped, It cannot be changed to running again while it's a destination.

cluster::*> vserver show
                               Admin      Operational Root
Vserver     Type    Subtype    State      State       Volume     Aggregate
----------- ------- ---------- ---------- ----------- ---------- ----------
Cluster     system  -          -          -           -          -
SVM_destination
            data    dp-destination        stopped     -          -
                               stopped
 

Additional Information

For SVM DR with -identity-preserve true, the destination SVM must be stopped as part of the SVM DR creation.

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.