Skip to main content
NetApp Knowledge Base

Is it possible to check the status of errors that occur during rebalancing with the volume rebalance show command

  1. Last updated
  2. Save as PDF
Views:
22
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Answer

  • No, errors that occur during rebalancing cannot be checked using the status of the volume rebalance show command.
  • In versions earlier than ONTAP 9.16.1, user-detectable messages were not available.
  • Therefore, aps.rebalance events and aps.aggr events were added, along with related EMS messages that can be detected in the event of a rebalance failure.
  • For versions earlier than ONTAP 9.16.1, no direct method exists to detect such errors through commands, logs, or messages.
  • Verification is only possible by upgrading to ONTAP 9.16.1.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.