Skip to main content
NetApp Knowledge Base

Encryption Conversion Start Failed to Get Encryption Type

  1. Last updated
  2. Save as PDF
Views:
21
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • NVE
  • Encryption Conversion

Issue

When performing an encryption conversion on a volume, the command fails to get encryption type:

::> volume encryption conversion start -vserver vs1 -volume vol1

Error: Command failed: Failed to start conversion on volume "vol1" in Vserver "vs21". Reason: Internal error.  Failed to get encryption type.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.