Skip to main content
NetApp Knowledge Base

NVIDIA SN2100 switch unable to manually set port speed to 10G

  1. Last updated
  2. Save as PDF
Views:
201
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • NVIDIA SN2100 Switch
  • Cumulus Linux 5.4.0

Issue

  • Some ports utilizing the 10G MAM1Q00A-QSA module are down and will not link up
  • The recommendation is to manually set the port speed to 10G and disable auto-negotiate on the switch
  • Running the commands below results in no changes to the interfaces:

nv set interface swp3-14 link auto-negotiate off
nv set interface swp3-14 link speed 10G
nv config apply

  • nv show interface <if_name> will show no changes to the port

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.