Skip to main content
NetApp Knowledge Base

Upgrading Nexus 3132 cluster network switch causes it to drop into switch boot prompt

Views:
769
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • Cisco Nexus 3000 series switches

Issue

  • When upgrading a Nexus 3000 series with compact or full image to release 7.0(3)I7(7) or 7.0(3)I7(8), it will reload and comes up in switch boot prompt.
  • Following error is seen:
Trim files after extracting TOR files ...
error while upgrading the firmware
/mnt/cfg/1 dir return 32 <<<<<<<<<<<<<<<<<<<<<

Config partitions are not partitioned properly.\nDisk will be re-initialized. <<<<<<<<<<<<<<<<<<<<<
 
switch(boot)#
 
prompt is then shown
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.