Skip to main content
NetApp Knowledge Base

Switch status shows marginal in SANnav as HTTPS protocol is not enabled

  1. Last updated
  2. Save as PDF
Views:
359
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade switches
  • FOS 9.x

Issue

  • Switch status is showing as marginal in SANnav as below 

Switch status Marginal.png

  • mgmtapp --show output confirms that https is disabled
G610:admin> mgmtapp --show
  REST Configuration:
        Interface State: Enabled
        Effective Protocol: HTTP only
        HTTP State: Enabled
        Session Count: 3
    Throttling configurations:
        Sample Requests     : 120
        Sample Time (in sec) : 30
        Idle Time (in sec)      : 3
  HTTPS Configuration:
        KeepAlive : Disabled
        KeepAliveTimeout : 15sec
 
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.