Skip to main content
NetApp Knowledge Base

New WWPN's added to the existing zone set via GUI is not visible in effective configuration

  1. Last updated
  2. Save as PDF
Views:
79
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade Switch (9.x)

Issue

  • New WWPNs added to exisiting zone set via GUI is not visible in effective configuration when a cfgshow command is ran in CLI.
  • New WWPN added is 21:00:00:xx:xx:xx:b9:f8

clipboard_eb4ded417d4f39686d9088ee9ddf5c508.png

Brocade_sansw1:admin> cfgshow
Effective configuration:
cfg:   cfg_name
zone:  zone_name
                20:01:d0:xx:xx:xx:9b:xx
                20:03:d0:xx:xx:xx:9b:xx
                20:06:d0:xx:xx:xx:9b:xx
                20:08:d0:xx:xx:xx:9b:xx
                21:00:00:xx:xx:xx:64:xx

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.