Skip to main content
NetApp Knowledge Base

Cannot Accept More NPIV Logins Because Lossless is Disabled in the Default Switch

  1. Last updated
  2. Save as PDF
Views:
174
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade Switch

Issue

  • When attempting new NPIV Logins to switch. The Switch will issue the following message in errdump -a
2021/09/21-12:33:35, [SWCH-1049], 205, SLOT 1 | FID 128, WARNING, SWITCH-01, Port 1 cannot accept more NPIV logins because lossless is disabled in the default switch.
  • There is also an error in SANNav seen below.
SWITCH-01 ( View Product Details )
Source
Address
1.1.1.1
FID
128
Description
Port 1 cannot accept more NPIV logins because lossless is disabled in the default
switch.
Severity
Warning
Message ID
SWCH-1049
Count
8

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.