Skip to main content
NetApp Knowledge Base

Failed to enable the Security policy on the Brocade switch due to mismatch of fddcfg

  1. Last updated
  2. Save as PDF
Views:
14
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade FC switch
  • FOS v9.x

Issue

  • Failed to enable the security policy on the new SAN switches.
  • Created an SCC policy, added the switches WWNs and attempted to activate the policy.
  • While activating the policy encountered following error.

Error: This command cannot be executed until the policy conflict in the fabric is resolved. Failed to activate new policy set on all switches. Failed to execute command.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.