Skip to main content
NetApp Knowledge Base

What config change is required for E-series after host HBA replacement?

  1. Last updated
  2. Save as PDF
Views:
136
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

E-series

Answer

  • Updating the host port identifiers on the storage array is necessary after replacing the HBA on the host side.
  • Specifically, the WWPN of the old HBA should be removed and the WWPN of the new HBA should be added to the host on the storage array.
  • For detailed steps, refer to Change host port identifiers for a host.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.