Skip to main content
NetApp Knowledge Base

Configure Network Settings prompt in SANtricity UI at each log in

  1. Last updated
  2. Save as PDF
Views:
45
Visibility:
Public
Votes:
0
Category:
e-series-santricity-os-controller-software
Specialty:
esg
Last Updated:

Applies to

SANtricity 11.80GA
E-Series E2800

Issue

  • The 'Configure Network Settings' prompt is encountered at each log in to the SANtricity UI after upgrading to 11.80GA.

configurenetwork.png

  • In logs, state-capture-data > netStateCapture shows both management ports are in use.

Controller A:

Connection Status  if0 :  Link Up
Connection Status  if1 :  Link Up

Controller B:

Connection Status  if0 :  Link Up
Connection Status  if1 :  Link Up

  • In logs, storage-array-profile shows both ports UP: 

 Ethernet port:     1                 
     Link status:   Up    
 Ethernet port:     2
     Link status:   Up 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.