Skip to main content
NetApp Knowledge Base

After power failure E-Series controller reported the error as "CA"

  1. Last updated
  2. Save as PDF
Views:
990
Visibility:
Public
Votes:
4
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • NetApp E-Series E2824
  • NetApp SANtricity OS
  • NetApp StorageGRID SG5712 Appliance
  • NetApp StorageGRID

Issue

  • After an uninterrupted power supply (UPS) lost all power to the array and hosts Array will not boot up
  • Rear 7-segment code reads CA (FPGA Reset E2800, E5700)
Rear 7-segment

 

 

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.