Skip to main content
NetApp Knowledge Base

iSCSI host setup fails on E-Series array with Login Failure error

  1. Last updated
  2. Save as PDF
Views:
299
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

NetApp E-Series

Issue

  • New Linux host setup fails to connect to E-Series array using iSCSI. The iSCSI login fails due to "Login response timeout".
  • The complete error message displayed in the host side application was:
Execute Host Command: Command error: iscsiadm --mode discovery --type sendtargets --portal 10.XX.XX.XX.XX: XXXX --op new: iscsiadm: Login response timeout. Waited 30 seconds and did not ger response PDU. iscsiadm: discovery login to 10.XX.XX.XX failed, giving up 2 iscsiadm: Could not perform SendTargets discovery: encountered non-retryable iSCSI login failure: 19

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.