Skip to main content
NetApp Knowledge Base

By-passed drive status is not cleared by replacing or reseating drive in E2812

  1. Last updated
  2. Save as PDF
Views:
172
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • E-Series E2812
  • StorageGRID Appliance SG5712
  • By-passed drive is reseated and replaced

Issue

  • By-passed status remains even after replacing and reseating the drive

      SHELF, BAY  STATUS     CAPACITY      MEDIA TYPE       INTERFACE TYPE  CURRENT DATA RATE  PRODUCT ID       FIRMWARE VERSION  CAPABILITIES  
      99,    0    By-passed            

  • RECOVERY-GURU-PROCEDURES indicates that by-passed disk is detected

BYPASSED_DRIVE-Recovery Failure Type Code: 64

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.