Skip to main content

This Site will be down for up to 3 hours on December 2, 2023 from 8 PM - 11 PM PST, to deploy an infrastructure update.

NetApp Knowledge Base

Does the target Aggregate need to be added to the aggr-list when performing SCV restore operation?

not set
Last Updated:

Applies to

SnapCenter plug-in for VMware vSphere (SCV)


Yes. The target Aggregate must be added into the 'List of Aggregates Assigned'.

Additional Information

  • Below error pops up if the Aggregate is not contained within 'aggr-list'


Reason: aggregate <Aggregate_Name> is not in aggr-list of Vserver <Vserver_Name>.

  • Use vserver modify command to assign the Aggregate specified in the error message to the Vserver in question.


NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device