Skip to main content
NetApp Knowledge Base

Can SnapCenter Plug-in for SAP HANA perform PIT restore and recovery?

Last Updated:

Applies to

SnapCenter (SC) Plug-in for SAP HANA version 4.3.2 and later


SC SAP HANA 4.3.2 and later provide support for PIT restore and recovery in accordance with the following guidelines:

  • Only Auto-Discovered HANA Single Container and MDC Single Tenant Systems are supported
  • PIT restore and recovery is not available for manual snapshots
  • System must use auto discovery and be enabled for automated restore and recovery with SnapCenter (PIT recovery using snapshots from earlier versions of SC SAP HANA are not supported)
  • PIT restore and recovery is not supported in SC SAP HANA versions 4.3.1Px and older

Additional Information

  • If you select a complete resource restore operation and automated recovery, the complete workflow is automated with SnapCenter
  • SnapCenter supports up to recent state, point in time, or to specific backup recovery operations
  • The selected recovery operation is used for the system and the tenant database
  • For more information, reference NetApp Technical Report TR-4614 SAP HANA Backup and Recovery with SnapCenter


NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device
  • Was this article helpful?