Skip to main content

This Site will be down for up to 3 hours on December 2, 2023 from 8 PM - 11 PM PST, to deploy an infrastructure update.

NetApp Knowledge Base

"No storage adapters installed" when SRA password uses special character

Last Updated:

Applies to

  • NetApp Storage Replication Adapter (SRA) 9.X
  • VMware Site Recovery Manager (SRM) Virtual Appliance


  • After uploading the SRA plugin to the SRM Appliance, the Storage Replication Adapters page in SRM reports the message No storage replication adapters installed.


Storage Replication Adapters

  • While setting the username and password for SRA adapter by running the following command: perl -I <UA-IP> administrator <UA-password>. if you receive below error:  sh: syntax error: unexpected newline


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device