Skip to main content
NetApp Knowledge Base

OCI installation in Windows 2008 fails with "There is a problem with this Windows Installer package" UAC control issue

  1. Last updated
  2. Save as PDF
Views:
176
Visibility:
Public
Votes:
0
Category:
oncommand-insight
Specialty:
oci
Last Updated:

Applies to

OnCommand Insight (OCI)

Issue

OCI installation in Windows 2008 fails with the following message:
There is a problem with this Windows Installer package.
A program run as part of the setup did not finish as expected.
Contact your support personnel or package vendor.

It may start with Figure 1 below, but not always. Figure 2 is seen for every instance.

Figure 1

1034431-a.PNG

 Figure 2
1034431-b.PNG

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device