Skip to main content

This Site will be down for up to 3 hours on December 2, 2023 from 8 PM - 11 PM PST, to deploy an infrastructure update.

NetApp Knowledge Base

Where to find RAM and processor information for nodes in Active IQ Digital Advisor

Last Updated:

Applies to

Active IQ Digital Advisor (AIQ)


  • The details of the type, speed, and number of processors, and the amount of RAM in each node cannot be seen in AIQ
  • To find this information please use the sysconfig -a command on the cluster command line interface (CLI)

Additional Information



NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device