Skip to main content
NetApp Knowledge Base

StorageGRID Appliance stuck at Starting Maintenance Mode

Views:
502
Visibility:
Public
Votes:
1
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

  • NetApp StorageGRID Appliances
  • StorageGRID 11.3

Issue

  • StorageGRID Appliance IPs were changed when it was running StorageGRID earlier than 11.3. 
  • StorageGRID Appliance stuck at Starting Maintenance Mode after clicking Maintenance Mode from Grid Manager, Nodes > Tasks tab:

starting-maintenance.png

  • 7-segment display on the Compute Controller shows HO, followed by a repeating sequence of two digits:
    HO -- Old IP address for Admin Network -- Old IP address for Grid Network HO

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device