Skip to main content
NetApp Knowledge Base

How to reboot the E-series controller from the StorageGrid Appliance Installer Page

  1. Last updated
  2. Save as PDF
Views:
134
Visibility:
Public
Votes:
4
Category:
storagegrid-webscale
Specialty:
sgrid
Last Updated:

Applies to

NetApp StorageGrid appliance

Description

The below steps can be taken if the customer is unable to reach their back-end SANtricity UI or SSH into the e-series controller to perform a reboot. 
 
NOTE: These steps will reboot both controllers at the same time. 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.